Jewelry Care & Instructions

jewelry care instructions

 

WIRE WRAPPED CRYSTAL JEWELRY

Please handle your crystal jewelry with care.  I only use tarnish resistant wires/ accents (unless noted otherwise), however, the level of care you take with your jewelry will determine its longevity. After wear, I recommend wiping the wires with a dry microfiber or polishing cloth. Avoid getting the wires and crystals wet as contact to perfumes, lotions, hand sanitizer, etc. may cause discoloration and tarnishing. Please care for your crystals and jewelry. They are not unbreakable and not shatter resistant. Wires may bend or break if enough pressure is applied.  

 

GEMSTONE STRETCH BRACELETS

When putting them on, I would recommend rolling them over your hand rather than stretching the bracelet to put your hand through. Also, avoid getting them wet. Any gold-colored beads/ spacers are tarnish resistant but may still tarnish over time. Use a microfiber/ polishing cloth to bring back its color/ luster.  Avoid over- stretching the elastic.

 

 

WHAT TYPE OF WIRES ARE USED?

I only use premium quality tarnish resistant wires for wire wrapped crystals and rings, unless noted otherwise.  Other materials used would be 14k gold fill or sterling silver which are hypoallergenic and nickel free.

 

HOW DO I FIGURE OUT MY SIZE?

  • Ring sizing:  You can download a free ring sizer that you can print at home, ask your local jeweler, or go to a hobby/ craft store and try on a ring sizer.
  • Necklace sizing:  Use a measuring tape or any type of string to measure the length of how you would like the chain to hang around your neck. Keep in mind that necklaces with pendants will hang longer. 
  • Bracelet sizing:  Use a measuring tape or any type of string to measure the length of how you would like the piece to fit to your wrist.  I would recommend wrapping the measuring tape/ string around your wrist so it's snug against your skin, then add at least 1/4 inch or a fingers width to it to get your final length.

 

HOW TO CARE FOR YOUR CRYSTALS

The crystals you wear or have around the house will need cleansing regularly. Crystals absorb negative and positive energy and often need to be cleansed. I cleanse all crystals before I send them on their way to you. Please ensure you regularly cleanse them too by following any method below.

  • Selenite Charging Plates: Leave your crystal(s) on one for up to 6 hours.
  • The Full Moon: Placing your crystals out under Moonlight on a windowsill is a gentle and penetrating method for recharging your crystals.
  • Rinse or bathe your crystals in rain-water, water from a spring, a stream, the beach, a river or sacred source, even in a waterfall (make sure you hold on to them or they can get swept away). Dry them naturally in gentle sunlight. IMPORTANT! First research to see if your crystal is water safe! --- This is not recommended for your crystal jewelry!
  • Smudging with white sage/ palo santo removes negative energy from crystals and rooms in your house. Pass your crystal through the smoke while asking it to be cleansed and purified.

 

FOR PALO SANTO, INCENSE & CLEANSING KITS

Reminder:  Never leave burning cleansers (incense, palo santo, sage, etc) unattended and always use a heat safe surface to set your cleanser on.

Disclosures: Always use a heat safe tray to set your cleansing kit or palo santo on, open windows or doors to let in fresh air and let out the smoke and negative energies.

Due to the nature of fire and the flammable nature of natural essential oils within plants, you hereby state that you absolve Stoned and Wired of all legal liability upon purchasing through my online shop or in person.  I cannot control or predict how herbs, flames, smudges, sage, wand, cleansers, incense, flowers, or candles will burn or how a person or animal/ pet could react to them.  It is your sole responsibility to practice responsible fire safety standards and routines within your home.  Please be advised that upon placing your order you agree to the terms of use, and the purchase agreement above.